SPYPOINT BF-6 - Manual (Page 4)

6 7
English
English
POWER
The battery level is shown on the LCD screen. When a single
line remains, the camera will continue to take pictures but we
strongly recommend changing the batteries before they are
empty. (See figure below)
AA batteries
This camera requires the use of 6 AA batteries (1.5V). The
use of alkaline or lithium batteries is strongly recommended.
Also note that the voltage of rechargeable AA batteries
(1.2V) is insufficient to power your SPYPOINT
® camera.
During the installation of the AA batteries, slide the switch
inside the battery case to ALK. Insert the batteries as indicated
inside the battery case. Exact polarity must be followed. We
also recommend the use of new batteries to ensure maximum
performance of your camera.
Lithium battery pack
This camera SPYPOINT
® can be powered by a rechargeable
lithium battery pack LIT-09/LIT-C-8 (sold separately, refer to
the section OPTIONS). This type of battery is less affected by
cold temperatures and lasts up to 3 times longer then an alkaline
battery. During the installation of the lithium battery, slide the
switch inside the battery case to LIT-09.
External (12V)
This camera can also be powered from an external 12-volt
DC input such as a 12-volt battery (KIT-12V/BATT-12V, sold
separately) or a 12-volt adapter (AD-12V, sold separately).
During the installation of a 12-volt connection, slide the switch
inside the battery case to ALK (the AA batteries can remain
safely inside the camera). If combined with a lithium battery
pack, slide the switch to LIT-09. For the accessories available,
refer to the section OPTIONS.
Power source Switch Position
• 6AA
• 12V
• 12V + 6AA
ALK
• LIT-09
• 12V + LIT-09
LIT-09
MEMORY CARD
Using a memory card is required to operate this camera
SPYPOINT
® . When the camera is ON and no memory card is
used, the screen displays "CArd" meaning to insert one. The
camera can accept memory cards up to 32 GB capacity. Before
inserting or removing the memory card, the camera must be
turned OFF. Failing to do so may cause loss of or damage the
pictures already recorded from the memory card. When the SD
card is full, the screen indicates "FUL". The following data
shows an approximate quantity of photos which can be recorded
by the camera depending on the memory card capacity.
RESOLUTION 2.0 GB 4.0 GB 8.0 GB 32 GB
3 MP
6 MP
2000
1600
4100
3200
8200
6300
32800
25300
VIDEO RESOLUTION
320 x 240
640 x 480
2h
65 min
4h
2h10
8h
4h10
32h
16h40
"BUSY" LED
The "BUSY" light, located next to the screen, lights up when
the camera is recording.