SPYPOINT BF-6 - Manual (Page 5)

8 9
English
English
SETTINGS
Picture Quality, Date, Time and Temperature
Turn OFF your camera; set switch MODE to SET/TEST and
turn ON the camera. Press MENU/OK. An "H" will flash on the
screen indicating that the camera is in High Resolution (6 MP).
Use the DOWN button if you want to reduce the resolution to
"L" (3 MP). Press MENU/OK to set the date and time (mm/dd/
yy, hh/mm). Use UP and DOWN to change the blinking digit.
Choose "F" or "C" to display the temperature in Fahrenheit (°F)
or Celsius (°C). Press MENU/OK to go to the next option. Once
finished, press MENU/OK and turn OFF the system to save the
changes.
Note: When the photo resolution is set to "L", the video
resolution is automatically set to 320 x 240 and if the photo
resolution is set to "H", the video resolution is automatically
set to 640 x 480.
MODE
PHOTO
Allows you to take pictures. When the PHOTO mode is
selected, the test light in front of the camera (see below) will
flash for 60 seconds to allow the user to leave the area without
being photographed.
VIDEO
Allows you to take videos. When the VIDEO mode is selected,
the test light in front of the camera (see above) will flash for
60 seconds to allow the user to leave the area without being
recorded.
SET-TEST
Allows the user to test the detection system of the camera.
When the SET/TEST mode is selected, no picture or video is
recorded. Walk perpendicularly in front of the camera. When
the camera detects movement, the light blinks to indicate that
normally, a photo or video would be recorded. If the system does
not detect the movement, increase the distance detection using
the wheel DISTANCE or realign the system differently. When
you understand how the device responds to detections, you can
better adjust the direction or the height of the installation.
How to properly install your camera
using the supplied installation strap:
(Recommended installation height: about 3 feet).
VIEW
Allows the user to view photos and videos directly on a TV
set. Turn OFF the camera and select VIEW. Connect the yellow
end of the RCA cable (supplied) into the VIDEO IN of the TV
and the other end into the TV OUT of the camera. Turn ON the
camera and the last recorded picture or video will appear. To
change the picture or the video, use the key UP or DOWN. If
you press MENU/OK, the following options will appear:
Test light