SPYPOINT TINY-D - Manual (Page 5)

8 9
English
English
1. Power button
2. Recording indicator LED
3. “UP” button
4. “BACK” button
5. “OK” button
6. “DOWN” button
7. ALK / RECH (switch for battery)
8. SD card slot
9. USB port
10. 12 volts jack
11. External trigger jack
12. TV OUT
13. Removable battery case
POWER
The battery level is shown in the «Report» mode.
(4/4 = full, 1/4= low) When the battery level shows 2/4,
the camera will continue to take pictures but we strongly
recommend changing the batteries before they are empty.
AA batteries
This camera requires the use of 6 AA batteries (1.5V). The
use of alkaline or lithium batteries is strongly recommended.
During the installation of alkaline batteries, place the switch
inside the battery case to “ALK” (i.e. alkaline). Insert the
batteries in the battery case as indicated and insert it inside
the camera (see figure below). Exact polarity must be
followed. We also recommend the use of new batteries to
ensure maximum performance of your camera.
Connector Connector
Top
Lithium battery pack
The camera SPYPOINT TINY-D can be powered by a
rechargeable lithium battery LIT-09/LIT-C-8 (sold separately,
refer to the section “OPTIONS”). This type of battery is less
affected by cold temperatures and lasts up to 3 times more
than an alkaline battery. During the installation of lithium
battery, place the switch inside the battery case to “ALK”
(i.e. alkaline). Insert the battery in the case as indicated and
insert it inside the camera (see figure below)
P INT SPY
TM
INT P SPY
Connector Connector
Top