SPYPOINT TINY-D - Manual (Page 8)

14 15
English
English
SETTINGS
To define the options of the camera. To configure the
system in English, hold the button “” until “Language” is
highlighted. Press “OK”, select “English” and confirm your
choice with “OK”. The system will change all the menus in
English by itself.
Time Start /
Time Stop: Allow the user to set the period of operation
of the camera. The start and stop time are
the hours during the camera is in action and
records pictures or videos. Example: if the
user selects a start time “7:00 am” and a stop
time “11:00 am”, the camera will only detect
for that period of time and will stay inactive
for the remaining hours. Press “OK” and use
“” or “” to adjust the hour. Press again
“OK” to set the minutes. When the time is
properly set, press “OK” once more to go
back to other settings.
For an activation of 24 hours, the same start
and stop time must be entered (example:
00:00 as start time and 00:00 as stop time.
These hours are the basic configuration of
your camera)
Note: The hours can be recorded over a
12 or 24 hours period. Refer to “Setting”/
“Time format” (00:00 means midnight)
Delay:
(10s/1m/3m/5m/
10m/15m/30m)
Select the time interval between two photos
or videos.
Additional setting: it is possible to decrease
the delay between detections to 10 seconds
(instead of 1 minute) by using the following
procedure. Note that the battery life will be
affected.
Turn OFF the camera. Press and hold the
“” button and turn the camera ON . “10sec
enabled” appears on the screen meaning
the minimum delay is now 10 seconds. If
this option is used, the 30 minute delay
disappears. To reset the camera to 1 minute
delay, follow the same procedure. “10sec
disabled” appears on the screen (see figure
below)
Multi-shot:
(1/2/3/4/5/6
consecutive shots)
Take up to 6 consecutive shots at each
detection, with a 10 second delay between each
photo. This option allows up to 6 pictures
from different angles when the camera is in
“Photo” mode.
10SEC DISABLED 10SEC ENABLED
10 sec delay 1 min delay