SPYPOINT X-CEL - Manual (Page 6)

10 11
English
English
SOUND RECORDING
For certain activities, such as hunting, the sound recording
may not be desired. To enable or disable the sound, press the
"H/L/SOUND" button and hold for 3 seconds. When the sound
recording is activated, the screen displays "ON" and when it is
turned off, the screen displays "OFF".
The X-CEL camera has an integrated microphone for
recording sound. The rubber cap for "normal conditions" can
record sound at all time. If recording video under water, it is
important to replace this rubber cap by the "underwater or
windy conditions" one to prevent infiltration of water inside
the camera. It is also recommended to use this rubber cap in
windy conditions. This rubber cap is located inside the camera,
under the screw (see figure below).
NUMBERS DISPLAYED ON SCREEN
LCD screen indicates, in the lower-left corner, the number
of videos recorded on the memory card. The numbers in the
middle of the screen refer to the remaining time available on
the memory card. When recording a video, these numbers
represent the duration of the video.
Microphone
Normal
conditions
Underwater
or windy
conditions
The replacement rubber cap is
located under the screw
DOWNLOADING TO A COMPUTER
To transfer or view photos and videos on a PC, you must first
turn the camera « OFF » and connect the USB cable (supplied) to
the camera and to your computer. The computer will recognize
the camera and install the software automatically. Click on
« My Computer » and select « Removable Disk ». Then click
« DCIM » and « 100DSCIM » to find all your photos and
videos.
Taking the SD card out of the camera and inserting it into the
computer port will achieve same results. If no SD slot is built
into the computer, a multi-card reader RD25-1 (sold separately)
must be used.
USB
TV OUT