SPYPOINT BLACKBOX-D (TINY-W3) - Manual (Page 4)

6 7
English
English
POWER
The battery level is shown in the top right corner of the
screen of the controller. When a single line remains, the
controller will continue to receive pictures but we strongly
recommend changing the batteries before they are empty.
(See figure below)
AA batteries
The controller requires the use of 6 AA batteries (1.5V). The
use of alkaline or lithium batteries is strongly recommended.
During the installation of the alkaline batteries, place
the switch to "ALK" (i.e. alkaline). Insert the batteries
in the compartment on the back of the controller. Exact
polarity must be followed. We also recommend the use
of new batteries to ensure maximum performance of your
Blackbox
TM -D .
Lithium battery pack
The controller can be powered by a rechargeable lithium
battery LIT-09/LIT-C-8 (sold separately, refer to the section
"Options"). This type of battery is less affected by cold
temperatures and lasts up to 3 times more than an alkaline
battery. During the installation of lithium battery, place
the switch to "LIT-09". Insert the lithium battery in the
compartment on the back of the controller as shown (see next
figure).
External (12V)
The controller can be powered from an external 12-volt DC
input such as a 12-volt battery (KIT-12V/BATT-12V, sold
separately) or a 12-volt adapter (AD-12V, sold separately).
During the installation of 12-volt battery, place the switch
to "ALK" (the AA batteries can remain safely inside the
camera). If combined with a lithium battery pack, slide the
switch to "LIT-09". To find the accessories available for the
12-volts, refer to the section "Options".
Installation of the LIT-09 battery pack