SPYPOINT BLACKBOX-D (TINY-W3) - Manual (Page 6)

10 11
English
English
SIGNAL
SYNCHRONIZE THE CAMERA
TO THE CONTROLLER:
Note: By default the camera SPYPOINT ® TINY-W3,
which is supplied with the Blackbox TM -D is synchronized
to the controller. Each additional camera (TINY-3) must be
synchronized with the Blackbox
TM -D.
Preparing the camera:
•
Set the name of the camera:
1. When "Settings" is selected, choose "Camera ID" and
press "OK".
2. Determine the name of the camera by pressing the ""
or "" buttons to change the letter and press "OK" to
go to the next space.
• Continue changing other parameters of the camera as
needed.
• To enable communication with the controller;
1. Select "Wireless" option and press "OK".
2. Select "On" and confirm the selection by pressing
"OK"; then on "" to return to the previous menu.
• Select the "Signal" mode and press "OK". The
camera searches for the controller.
Preparing the controller Blackbox TM -D:
When "Signal" mode is selected, press "OK" to "Add
new Camera".
The "Sync" icon changes from red to green in the camera
screen when synchronization is successful.
Note:
•
You can synchronize up to 10 cameras to a single
controller.
• If the name of the camera is changed, it is necessary to
resynchronize the devices by following the steps in the
"Preparing the camera" and "Preparing the controller"
sections.
• The "Reset All" option allows to find the original
settings.
• It is possible to easily retrace the BLACKBOX TM -D
controller with a buzzer signal by pressing the FN
button on the RC-1 remote control. The remote control
must be previously synchronized with the camera,
which communicates with the controller. The remote
control (sold separately) is part of the product range
compatible with the REMOS
TM technology.