SPYPOINT S-TINY-3 - Manual (Page 10)

18 19
English
English
Delay:
(10s/1m/3m/5m/
10m/15m/30m)
Select the time interval between photos or
videos.
Additional setting: it is possible to
decrease the delay between detections to 10
seconds (instead of 1 minute) by using the
following procedure. Note that the battery
life will be affected.
Turn OFF the camera. Press and hold the
"
 " button and turn the camera ON . "10sec
enabled" appears on the screen meaning
the minimum delay is now 10 seconds. If
this option is used, the 30 minute delay
disappears. To reset the camera to 1 minute
delay, follow the same procedure. "10sec
disabled" appears on the screen (see figure
below)
Multi-shot:
(1/2/3/4/5/6
consecutive
shots)
Take up to 6 consecutive shots at each
detection, with a 10 second delay between
each photo. This option allows up to 6
pictures from different angles when the
camera is in "Photo" mode.
Wireless:
(On/Off)
Enables or disables the wireless
transmission of images to the Blackbox-
D
TM controller (supplied with the TINY-W3/
S-TINY-W3).
When the transmission is enabled:
• Only pictures are transmitted to the
controller, not videos.
• The quality of the photos on the controller
is reduced to maximize transmission:
10MP = 800 x 600 pixels
5MP = 640 x 480 pixels
3MP = 320 x 240 pixels
• When in " Time Lapse" mode, photos
are sent to the controller except for the
" 30s" setting.
• When the delay setting " 10s" is selected,
the time between each detection is
calculated when the transmission is
completed. For example, if the transmission
takes two seconds, the time between the two
detections is 12 seconds.
Note: When the wireless option is activated,
it is only possible to take up to 2 consecutive
shots. 10SEC DISABLED 10SEC ENABLED
10 sec delay 1 min delay