SPYPOINT S-TINY-3 - Manual (Page 5)

8 9
English
English
REAR VIEW
BOTTOM VIEW
7.
10. 9.
11.
13.
8.
12.
OK
BUSY
1.
2.
3.
4.
5.
6.
1. Power button
2. LED recording indicator
3. "UP" button
4. "BACK" button
5. "OK" button
6. "DOWN" button
7. ALK / RECH (switch for battery)
8. SD card slot
9. USB port
10. 12-volt jack
11. External trigger jack
12. TV OUT
13. Removable battery case
POWER
The battery level is shown in the " Report " mode.
(4/4 = full, 1/4= low) When the battery level shows 2/4,
the camera will continue to take pictures but we strongly
recommend changing the batteries before they are empty.
AA batteries
This camera requires the use of 6 AA batteries (1.5V). The use
of alkaline or lithium batteries is strongly recommended. Also
note that the voltage of rechargeable AA batteries (1.2V)
is insufficient to power your SPYPOINT
® camera. During
the installation of alkaline batteries, place the switch inside
the battery case to "ALK" (i.e. alkaline). Insert the batteries
in the battery case as indicated and insert it inside the camera
(see figure below). Exact polarity must be followed. We also
recommend the use of new batteries to ensure maximum
performance of your camera.