Stack-On GCD-9216-5 4254-0707 - Manual (Page 2)

CABINET MOUNTING INSTRUCTIONS
Selecting a Location
Your Security Cabinet should be installed in an isolated, dry and secure area.
For greater security the cabinet must be fastened to a solid surface with a minimum space on either side.
Ideally the cabinet would be installed on the side wall of a closet. (See figure 4)
The cabinet should be flat against the wall and floor. Remove the baseboard if necessary. (See figure 5)
Insert the plastic plugs in the cabinet's top mounting holes if you are not installing the Pistol-Ammo cabinet
on the top of the security cabinet.
Wall Mount Option
The (4) mounting holes in the rear of the cabinet must line up with the 16" centers of the wall studs. Drill
new holes in the cabinet if necessary. (See figure 5)
Drill (4) 3/16" pilot holes into the wall studs and secure the cabinet to the wall using (4 ea.) lag bolts and
washers. (See figure 5)
Floor Mount Option
The (4) mounting holes in the rear of the cabinet must line up with the 16" centers of the wall studs. Drill
new holes if necessary. (See figure 5)
Drill (2) 3/16" pilot holes into the wall studs lining up with the top (2) mounting holes in the back of the
cabinet. Secure the cabinet to the wall using (2) lag bolts and washers.
Drill (2) pilot holes and secure the cabinet bottom to the floor with (2) lag bolts and washers.
FOAM INSTALLATION
IMPORTANT: Mount the unit to the wall or floor before installing the foam lining.
Installation of Foam Kit
Note: Adhesive-backed foam pads have been included for the right side compartment only
Remove the upper 2" of backing from the lower back foam (F) Gage to the rear barrel rests and
remove the remaining backing while pressing the foam into place. (See figure 6)
Apply the upper rear foam (G) as shown in figure 6. Gage to the rear barrel rests.
Remove the upper 2" of backing from the lower side foam (H). Gage to the side barrel
rests and remove the remaining backing while pressing the foam into place. (See figure 7)
Apply the upper left side foam (J) as shown in figure 7. Gage to the side barrel rests.
Apply the upper right side foam (K) as shown in figure 7. Gage to the side barrel rests.
4254-0707
2 15
16"
CENTERS
CABINET
TOP VIEW
MINIMUM
4
5
7
J
H
H
K
6
F
G