Stack-On PDS-500 9004-0708 - Manual (Page 2)

WALL MOUNTING (Model PDS-505 only)
For best results this safe should be mounted in a dry and secure area.
The hardware used may vary depending on the type of wall and spacing of wall supports.
The safe must be fastened to a solid and secure wall structure such as wall studs that
can support a minimum of 30 lbs. (approximate weight of the safe when empty). These
instructions provide a general guideline for hanging this unit. Please contact your local
hardware retailer for fastening hardware for your particular wall.
The safe must be mounted flush to the wall. It is important that the safe is securely
fastened to the wall. These units are heavy and could cause injury.
TIP: A securely fastened cleat (A) mounted level and at the appropriate height will aid in
mounting the safe.
MAINTENANCE FOR KEY AND ELECTRONIC SAFES
If the door of the safe starts to rub on the door frame, open the door per the instructions above.
By the door hinges you will find a threaded stem. Use an Allen Wrench to tighten the threaded stem. This will help
realign the door and give you trouble free access to the contents of your safe.
IMPORTANT
Keep keys and your combination number in a secure
place, away from children. Keep this record of your serial
number and combination in a secure place separate from
your safe. To order a replacement key set, follow the
instructions on the attached form.
STACK-ON PRODUCTS COMPANY
P.O. BOX 489
WAUCONDA, IL 60084
TURNING THE KEYPAD SOUND OFF/ON
You can turn off the "Beep" sound of the keypad by entering the code 633.
To turn the "Beep" sound on, enter the code 66.
DRAWER MOUNTING
For best results this safe should be mounted in a dry and secure area.
Select an appropriate sized drawer for your safe. Place the safe in the
drawer and try opening and closing both the safe and the drawer.
Before mounting the the safe to the bottom of the drawer, check to make
sure the bottom of the drawer is recessed so there will be enough
clearance for the bolts. There should not be any interference from the bolts
when opening or closing the drawer.
Drill holes in the drawer bottom and secure the safe with the bolts.
A
9004-0708 12
2