STEMCO Tractor Interface Module - Manual (Page 5)

5
PeopleNet (LCD) Driver Terminal
Display Line 1
Normal Operation
The TIM provides useful information on the first (top) line of the driver terminal to support
driver pre-trip inspections and help drivers to monitor alert conditions. This information will
always be sent to line one on the display but will only be visible by the driver/maintenance
personnel when the terminal is on the home screen. If the display is not on the home screen,
you can get there by simply p
ressing the ▲(up arrow) several times. After this action, you
should be able to see BatRF TPM information on line 1 of the display.
Pressure & System Status
The left half of the first line on the display provides summary information. concerning the
pressure status and if any faults are present.
First Character
– The first character is used to show whether or not the TIM is operational
and communicating with the PeopleNet on board computer. The first character slowly flashes
on and off. This character can be any one of the following:
“*” –
The system status is good and there are no faults present. All of the bound
sensor tire pressures are above the low pressure limit and the vehicle is not in motion.
“Slow Twirling Bar” – Same as * except vehicle is in motion.
“ ! ” - Indicates that there is a low pressure alert or a system error. Typical pressure
alerts will be either a low or flat tire alert and a system error can occur when no GPS
data is available.