STEMCO Tractor Interface Module - Manual (Page 6)

6
*OK BatRF
–
This message indicates that all bound tires are above the low limit pressure. If
the “OK” is shown in upper case it means that the communications with WebBAT (a remote
web service that sends the email/SMS alerts is working correctly). If shown in lower case it
means the remote connection to WebBAT was not successful. The TIM periodically transmits
messages to WebBAT. When power is applied to the TIM, the status will show a lower case
“ok” until the TIM has successfully received a response back from WebBAT (usually takes less
than 5 minutes). When there are no alerts or errors the information is sent to line 1 passively;
in passive mode the driver can chose to display other line 1 items such as the clock and the
BatRF TIM will not cause the display to return to the TPM display.
Bound Tires/Sensors
“TPM##”
- Where ## is the total number of tires (not sensors) that are currently bound to the TIM.
“S^^” -
Where ^^ is the total number of sensors that are currently bound.
In Cab Alerts
Pressure Alert Line 1
After a full screen alert has been issued the alert information continues to update on line 1 of
the screen. When an alert is present the TIM forces the information to appear on line 1 (no
longer passively).
Pressure Alert Line 1
! {Alert Type} Tire TPM## S^^
The generic message will be displayed first
followed by one or more tire specifics. The
{Alert Type} will either be "Low" or "Flat"
depending on which criteria are meet. If
more than one tire is below the limit and one
is at a low level and the other is at the flat
level then the word "Flat" will be displayed.
Tire Pressure Specific Message
!###PSI
If one or more of the sensors that are bound
report pressures equal to or below the low limit
then the display will alternate between a warning
message and the tire with the lowest pressure.