Summit CP96 - Manual (Page 5)

4
Location of Parts
1. Top cover
2. Wire shelf of freezer compartment
3. Thermostat
4. Glass shelf
5. Crisper cover
6. Crisper
7. Adjustable leg
8. Long rack
9. Short rack
10. Bottle rack
INSTALLATION INSTRUCTIONS
1. Before using your appliance
a. Remove the exterior and interior packing, including the foam base and all
adhesive tape. To remove any remaining tape or glue, rub the area briskly with
your thumb. Tape or glue residue can also be easily removed by rubbing a
small amount of liquid dish soap over the adhesive with your fingers. Wipe with
warm water and dry.
b. Do not use sharp instruments, rubbing alcohol, flammable fluid or abrasive
cleaners to remove tape or glue. These products can damage the surface of
your refrigerator.
c. When moving the appliance, do not tilt it more than 45° from the upright
position.
d. Before connecting the appliance to the power source, let it stand upright for
approximately 30 minutes. This will reduce the possibility of a malfunction in
the cooling system from handling during transportation.
e. Clean the interior surfaces with lukewarm water using a soft cloth.
2. Installing your appliance
WARNING: Keep flammable materials and vapors such as gasoline away from the
refrigerator.
• Place your appliance in a well-ventilated area on a floor that is strong enough
to support it when fully loaded. To level your appliance, adjust the leg at the
front of the appliance.