Summit CP96 - Manual (Page 8)

7
6. Set the freezer door in place, and finally refit the top cover.
4. Electrical connection
•
This appliance should be properly grounded for your safety. The power cord of
this appliance is equipped with a three-prong plug which mates with standard
three-prong wall outlets to minimize the possibility of electrical shock.
•
Do not under any circumstances cut or remove the third ground prong from the
power cord supplied.
•
Plug the appliance into an exclusive, properly installed, grounded wall outlet.
Any questions regarding power and/or grounding should be directed toward a
certified electrician or an authorized Summit service center.
•
It is recommended that a separate circuit serving only this appliance be provided.
Use a receptacle that cannot be turned off with a switch or pull chain.
•
The use of extension cords is strongly discouraged.
•
This appliance requires a standard 115/120-volt, 60 Hz electrical outlet with
three-prong ground and a 15-amp fuse. To prevent accidental injury, the power
cord should be secured behind the appliance and not left exposed or dangling.
NOTE: Before performing any type of installation, cleaning or removing a light bulb,
turn the thermostat control to 0 (OFF) and then disconnect the unit from the
electrical power source. When you are finished, reconnect the refrigerator to the
power source and reset the temperature control to the desired setting.
 Warning 
Improper use of the grounded plug can result in the risk of electrical shock. If the
power cord is damaged, have it replaced by an authorized service technician.