Summit FFBF171SS - Manual (Page 9)

8
Remove the handle screws that hold the handle to the door
on the left side as illustrated, and transfer them to the
covered holes on the right side. Use the screws to affix the
handle to the right side of the door and place the hole
coverings over the holes on the left side of the door.
Door handle reversal (if door swing is reversed)
Do the same for each of the doors.
The walls of the refrigerator are equipped with a series of runners so that the
shelves can be positioned as desired. To remove a shelf, gradually pull it in the
direction of the arrows until it comes free, then reposition as required.
Movable shelves
Wait for at least 4 hours to allow the system to settle before switching on.
Before starting up the appliance
Before you begin operating your refrigerator-freezer, check the following points
for safety:
• Is the appliance standing firmly on the floor?
• Is there sufficient space for good air circulation?
• Is the interior clean? (See Cleaning and Care.)
Now connect the appliance to the power supply.
Operation
Control panel
The control panel is located at the top front of the unit. Among other things, it
contains the thermostat which controls the temperatures inside the Refrigerator
compartment and the Freezer compartment.
This appliance displays temperatures in Celsius degrees (
°C). You can use the
chart below to estimate corresponding temperatures in Fahrenheit (
°F).
°C °F °C °F °C °F °C °F
-25 -13.0 -18 -0.4 1 33.8 8 46.4
-24 -11.2 -17 1.4 2 35.6 10 50.0
-23 -9.4 -16 3.2 3 37.4 15 59.0
-22 -7.6 -15 5.0 4 39.2 20 68.0
-21 -5.8 -10 14.0 5 41.0 25 77.0
-20 -4.0 -5 23.0 6 42.8 30 86.0
-19 -2.2 0 32.0 7 44.6