Summit FF1074IM - Manual (Page 7)

6
Turning the water on
NOTE: Be very careful when you
tighten the compression nuts that
you do not overtighten them and
destroy the compression sleeving
and the end of the soft copper
tubing. If this happens, you will have
to cut off the end of the tubing,
purchase a new compression sleeve,
and start over. Be careful and go
slowly!
1.
Turn on the water supply and
check the shut-off valve for
leakage. If necessary, refer to the
side diagram, and tighten the
compression nut on the shut-off
valve in small increments until the
leakage just stops. Wipe off the
connection with a cloth each time
you check for leaks.
2. Check the water valve for any
leakage. If necessary, tighten the
compression nut (see the side
diagram) in small increments until
the leaking just stops
.