Regency Hampton H35 Large Gas Stove - Manual (Page 37)

Hampton® H35-2 Direct Vent Freestanding Gas Stove
37
INSTALLATION
2) Assemble side shelf.
a) Attach front support to the underside of the side shelf with 2
screws as shown below.
9) Re-install the Glass Front and Cast Top.
4) Tighten screws (installed from step 2C) to secure the shelf - as shown
below.
.
5) Repeat steps 2- 4 for the other side.
6) Re-install the Cast Top.
7) After Cast top has been installed - the gap between the side shelf
and cast top can be adjusted by sliding it in or out. Once in fi nal
position - tighten 2 screws (shown in step 2b) as shown below.
8) Repeat on other side.
1) Lift off the Cast Top. 3) Flip assembled shelf over - line up the bracket on the unit as
shown below.
Note: Orient the shelf so the support bracket is to the front of the
unit.
b) Attach bracket to the underside of the side shelf with 2
screws as shown below.
Note: Do not tighten screws all the way.
c) Install 2 screws partially onto bracket in locations shown below -
in preparation for installation.
Front
Support Bracket
Line up to this edge
OPTIONAL SIDE SHELVES INSTALLATION