Regency Hampton H35 Large Gas Stove - Manual (Page 7)

Hampton® H35-2 Direct Vent Freestanding Gas Stove
7
INSTALLATION
IMPORTANT MESSAGE
SAVE THESE
INSTRUCTIONS
The Direct Vent Freestanding Gas Stove must
be installed in accordance with these instructions.
Carefully read all the instructions in this manual fi rst.
Consult the building authority having jurisdiction
to determine the need for a permit prior to starting
the installation.
Note: Failure to follow the instructions could
cause a malfunction of the heater which
could result in death, serious bodily
injury, and/or property damage. Failure
to follow these instructions may also
void your fi re insurance and/or warranty.
Note: These instructions take precedence over
Simpson Dura-Vent instructions.
SPECIFICATIONS
Fuels: H35-NG2 is approved for use with natural
gas.
H35-LP2 is approved for use with
liquefi ed petroleum gases (propane).
Electrical: 120V A.C. system.
Circulation Fan: Variable speed, 125/75.
Log Sets: Ceramic fi bre, 7 per set.
Vent System: Coaxial (6-5/8" outer / 4" inner liner)
rigid fl ue and termination cap.
The efficiency rating of the appliance is a
product thermal efficiency rating determined
under continuous operating conditions and was
determined independent of any installed system.
INFORMATION FOR
MOBILE /
MANUFACTURED HOMES
AFTER FIRST SALE
This Hampton ® product has been tested and listed by
ITS Testing Services as a Direct Vent Wall Furnace
to the following standards:
CGA-2.17-M91, and ANSI Z21.88b-2007/CSA
2.33b-2007.
This Direct Vent System Appliance must be
installed in accordance with the manufacturer's
installation instructions and the Manufactured Home
Construction and Safety Standard, Title 24 CFR,
Part 3280, or the current Standard of Fire Safety
Criteria for Manufactured Home Installations,
Sites, and Communities ANSI/NFPA 501A, and
with CAN/CSA Z240-MH Mobile Home Standard
in Canada.
This appliance installation must comply with the
manufacturer's installation instructions and local
codes, if any. In the absence of local codes follow
the current National Fuel Gas Code, ANSI Z223.1
and the current National Electrical Code ANSI/NFPA
70 in the U.S.A., and the current CAN/CSA B149.1
Gas Installation Code and the current Canadian
Electrical Code CSA C22.1 in Canada.
This Hampton ® Mobile/Manufactured Home
Listed appliance comes factory equipped
with a means to secure the unit.
This Hampton ® Mobile/Manufactured Home
listed appliance comes equipped with a
dedicated #8 ground lug to which an 18
gauge copper wire from the steel chassis
ground must be attached.
This appliance may only be installed
in an aftermarket permanently located,
manufactured (USA only )or mobile
home, where not prohibited by local
codes.
This appliance is only for use with the type
of gas indicated on the rating plate. This
appliance is not convertible for use with
other gases, unless a certifi ed kit is used.