Telematrix DC550 - Manual (Page 13)

13
Wall Mounting the Spectrum PLUS TM Telephone
NOTE: Be sure that all line cord connections are made prior to installing the Wall Mount Wedge.
An optional direct connect coaxial power supply can be used or the provided power supply can be used.
Connecting the Handset Cord
A 10-foot modular coil handset cord is
provided. (
Be sure that the wall/desk
elevation stand has not been
attached). To i nstall the co rd, simply
plug the
short straight end o f the
handset cord into the modular jack on
the handset. The
long straight end of
the hands et c ord pl ugs i nto the jac k
labeled “Hands et” l ocated on the b ot-
tom of the SpectrumPLUS
TM base unit.
Place t he l ine co rd i nto t he h andset
coil c ord channel lo cated d irectly
below the jack.
The S pectrum P LUS TM was design ed to be
conveniently w all mou nted w ithout r equiring
additional hardware.
Follow these easy steps:
1.The handset r etaining c lip mu st be in th e
correct p osition t o se cure t he h andset i nto
the handset cradle. Engage the clip with your
fingers a nd pu ll th e c lip f orward ( towards
you), rotate th e c lip 180º an d s nap th e c lip
back in to pla ce ( figure 1) . Th e r etaining c lip
cannot be removed.
RETAINER CLIP
figure 1
1. UNS NA P
2. RO TAT E 1 80 .
3. SN AP I NTO P LA CE.
NOTE: CLIP IS
SPRING LOADED
1.LIFT CLIP OUT WITH
FINGERS. IT CANNOT BE
REMOVED BECAUSE IT IS
SPRING LOADED.
2. ROTATE THE CLIP 180 0
AND IT WILL SMAP BACK
INTO THE OPPOSITE
POSITION. AN
EXTENDED PLAS-
TIC BUMP WILL
BE FACE-UP FOR WALL
MOUNTING