Unisteer 8012290-01 Ford Torino Small Block Rack Kit 1968-70 - Manual (Page 12)

Page 12 657220
10. Install the outer tie rod ends and tighten lock nut on steering arm to 45 ft. lbs. Adjust the toe by eye so
you can drive to an alignment shop. This is done by turning the inner end. You do not have to take off
outer end to adjust. Tighten jam nut once toe is set. Screw in Zerk fitting and grease.
11. The power steering pump is an easy install and comes with the pump brackets attached to it. If your
car was equipped with power steering you will need to remove the stock pump and brackets that held
it on the motor. Bolt on the pump using the provided hardware with the longer spacer on the lower
bolt and the shorter spacer up top in-between the two mounting brackets. Measure the belt length
and install belt. Tighten the hardware.