Unisteer 8012290-01 Ford Torino Small Block Rack Kit 1968-70 - Manual (Page 6)

Page 6 657220
3. If equipped remove the power steering pump, brackets and lines. All the pieces removed will not be
used.
4. You need to modify your stock column slightly. Remove the steering column by taking off the floor
& dash mount and disconnecting the wiring harness. Do not remove the steering wheel. Pull out the
end of the column shaft with the rag joint. Cut off the rag joint assembly at the end closest to the joint
itself. Tap the inside column tube into the outer column tube far enough to tap the bearing in. Next
install the supplied column tube bearing by tapping it in with a hammer. Then tap the column insert
into the hallow shaft you just cut so you can line the u-joint yoke up flush with the end of the column
shaft and insert to drill and pin in place. Next slide the brass washer up on the column shaft and u-
joint. That is all that is needed for modification to the column.