Unisteer 8061090 Corvette Pump Kit 1963-82 User Manual
Page 4
Advertising
Page 4
657440
3. Route pressure and return lines from rack housing along the driver side frame rails and up to the
pump. Make sure you route the lines free of sharp or hot objects.
4. When connecting your pressure and return lines, your pressure line goes from the lower port on the
rack housing to the banjo fitting on the pump. The return line goes from the top port on the housing to
the plastic reservoir on the pump.
5. Measure proper belt length for your application. Install belt by setting proper tension and tighten the
pump brackets.
Advertising
This manual is related to the following products: