UVP B-100 Series - Manual (Page 2)

Replacement Parts List
Parts lists are provided for the B-100 lamp models. Two
parts lists are shown: one for the Cool-Touch housing
lamps and one for the aluminum housing lamps. For
additional ordering information or an authorized
dealer, contact:
UVP, LLC, Upland, California | (800) 452-6788
(909)946-3197
Ultra-Violet Products Ltd., Cambridge UK
+44(0)1223 420022
NOTE: An RGA (returned goods authorization) number
is required prior to returning any products to UVP.
Contact UVP’s offices to obtain a number.
B-100A, B-100A/R, B-100Y
115 VOLT, 60 Hz; 220 VOLT, 50 Hz
(Note: B-100A/R NSN 6635-611-5617 ordering number)
PART NO. PART NAME
34-0054-01 SPOT BULB
36-0043-02 SOCKET, MEDIUM BASE
38-0168-03 BEZEL & UV FILTER ASSEM.
38-0168-04 BEZEL & YELLOW FILTER ASSEM.
77-0005-01 LAMP HEAD ASSEMBLY WITH 8ft. CORD, 115V
77-0005-02 LAMP HEAD ASSEMBLY WITH 8ft. CORD, 220V
77-0005-03 LAMP HEAD ASSEM. WITH 20ft. CORD, 115V
77-0005-04 LAMP HEAD ASSEM. WITH 20ft. CORD, 220V
88-0016-01 BALLAST REPLACEMENT KIT, 115V
88-0016-02 BALLAST REPLACEMENT KIT, 220V
19-0124-01 LAMP VISOR
B-100AP, B-100AP/R, B-100YP
115 VOLT, 60 Hz; 220 VOLT, 50 Hz
PART NO. PART NAME
34-0054-01 SPOT BULB
36-0043-02 SOCKET, MEDIUM BASE
38-0168-01 BEZEL AND UV FILTER ASSEMBLY
38-0168-02 BEZEL & YELLOW FILTER ASSEM.
88-0016-01 BALLAST REPLACEMENT KIT, 115V
88-0016-02 BALLAST REPLACEMENT KIT, 220V
77-0007-01 B-100AP LAMP HEAD ASSEMBLY, 115V
77-0007-04 B-100AP LAMP HEAD ASSEMBLY, 220V
77-0007-05 B-100AP LAMP HEAD ASSEMBLY, 115V
77-0007-06 B-100AP/R LAMP HEAD ASSEMBLY, 220V
77-0007-07 B-100YP LAMP HEAD ASSEMBLY, 115V
77-0007-08 B-100YP LAMP HEAD ASSEMBLY, 220V
Models:
B-100A
B-100A/R
B-100Y
Models: B-100A,
B-100A/R, B-100Y
Transformer
Ballast Base
Bezel & Filter
Assembly
Lamp Head
Assembly
Bulb Replacement
To replace the bulb, first remove the filter assembly:
Expand front bezel tabs and slide front bezel off the
lamp assembly. Expand the two silver filter assembly
spring clips outward to release filter assembly from the
lamp body.
When replacing the bulb, screw bulb in tightly to prevent
loosening from heat expansion and contraction during
lamp operation.
Bulb Standardization
For testing uniformity, a standard bulb intensity is
required.
A special light meter calibrated for measuring ultraviolet
intensity is required to check bulb standardization.
The UVX Radiometer and UVX-36 sensor or the J-221
UV Meter employ a dense ultraviolet filter and is
specifically calibrated to read ultraviolet intensity of
365nm in mW/cm² from a line source lamp. An ordinary
light meter will not deliver readings of ultraviolet energy.