Brother FAX-1960C - Manual (Page 44)

28
5
Entering Fax mode
5
To enter fax mode, press (Fax), and
the key will glow green.
Faxing from the ADF
5
a
Make sure you are in Fax mode .
b
Put the document face down in the ADF.
c
Dial the fax number.
d
Press Black Start or Color Start.
The machine starts scanning the
document.
Note
• To cancel, press Stop/Exit.
• If the memory is full, the fax will be sent in
real time.
Color fax transmission
5
Your machine can send a color fax to
machines that support this feature.
However, color faxes cannot be stored in the
memory. When you send a color fax, the
machine will send it in real time (even if
Real Time TX
is set to Off).
Canceling a fax in progress
5
If you want to cancel a fax while the machine
is scanning, dialing or sending, press
Stop/Exit.
Broadcasting
(Black & White only)
5
Broadcasting is when the same fax message
is automatically sent to more than one fax
number. You can include Groups,
One-Touch, Speed-Dial numbers, and up to
50 manually dialed numbers in the same
broadcast.
After the broadcast is finished, a Broadcast
Report will be printed.
a
Make sure you are in Fax mode .
b
Load your document.
c
Enter a number. Press OK.
You can use either a One-Touch, a
Speed-Dial, a Group, or a manually
entered number.
d
Repeat c until you have entered all the
fax numbers you wish to broadcast to.
e
Press Black Start.
Note
• If you did not use up any of the numbers
for Groups, you can ‘broadcast’ faxes to
as many as 160 different numbers.
• The available memory will vary depending
on the types of jobs in the memory and the
number of locations used for
broadcasting. If you broadcast to the
maximum numbers available, you will not
be able to use dual access.
• If the memory is full, press Stop/Exit to
stop the job. If more than one page has
been scanned, press Black Start to send
the portion that is in the memory.
Sending a fax
5