Waterpik WP-480 Owners Manual - Manual (Page 11)

E
N
G
LI
S
H
11
Water Flow Problems
If there is no water flow from the installed showerhead, confirm that the
previous shower washer is not in the shower pipe, and confirm that there
is only one washer in the pivot ball.
Leakage
If leakage occurs at pivot ball connection, confirm that only one washer is
on top of the screen. If still leaking, grate a bar of soap across the shower
pipe threads to seal.
Care and Cleaning of Diverter Valve
Clean filter screen (inside pivot ball – see product description, page 7) at
least once a year or whenever you notice a drop in water pressure from your
showerhead. To clean, remove diverter valve from large nut. Remove the
pivot ball from the shower pipe and gently brush the filter screen, located in
the pivot ball. You can also back flush the filter screen by holding the pivot
ball under a running faucet with the small end (nonthreaded) up in the water
stream. To replace showerhead, refer to installation instructions.
Battery Care and Disposal
If you use your Water Flosser once a day or less, it is recommended you
charge the battery pack overnight, once a week. If you use it twice a day
Plaque Seeker ® Tip
To use the Plaque Seeker ® tip, place
the tip close to the teeth so that the
bristles are gently touching the teeth.
Gently glide tip along gumline, pausing briefly between teeth to gently
brush and allow the water to flow between the teeth.
Cleaning
Wipe the exterior of the Water Flosser, when necessary, with a soft cloth
and mild non-abrasive cleanser.
Before cleaning the charger, unplug from the electrical outlet. Clean the
charger with a soft damp cloth. Do not use any cleansers when cleaning
the charger or contacts.
Periodically you may clean the contacts on the battery pack, the charger
(unplug first) and the Showerpik
® power handle with a soft damp cloth.
Do not use any cleansers.
CLEANING AND TROUBLESHOOTING yOUR WATERPIk ® WATER FLOSSER
Metal Contacts