Weidmuller G438 Ultra SlimPak - Manual (Page 4)

110.2
TS32 RAIL
105.2
TS35 RAIL
88.5
12.6
90.0
Rated data
Input
Range
Impedance
Maximum ratings / type of protection
Field device excitation
Other input specification
Other input specification
Output
Range
Load
Burnout level
Zero / Span adjustment
Protection
Other output specification
Other output specification
Supply
Range
Consumption
Other supply specification
General
Accuracy
Linearity
Temperature coefficient (drift)
Transmission frequency
Response time. 90% span
Other general specification
Status LED
Isolation (# of ports)
Operating / Storage temperature
Housing (mounting)
Dimensions (L x W x H)
Wire range (conductor size)
Insulation stripping length
Tightening torque
Approvals
Ordering data
Ultra SlimPak
Heat sink (width)
Shunt resistor
Potentiometer, 3 wire variable resistance
100 M to 100kM, resistance end to end
1Meg M minimum
500mV, 5mA maximum
DC current or voltage
0-1mA, 0-20mA, 4-20mA, 0-5Vdc or 0-10Vdc, DIP switch selectable
<7.5k M (0-1mA), <600M (0/4-20mA), >500M (0-5V), >1000M (0-10V)
0 to 80% of full scale input, DIP switch selectable / 20 to 100% of full scale input, DIP switch selectable
DC voltage
9 to 30Vdc, inverter isolated
1.5W typ., 2.5W max. (200mA inrush at 9Vdc)
±0.1% maximum at 25°C
included in accuracy
±0.05% of full scale/°C, max.
<200mS typical
power green (ON=OK)
1800V (2 port) between power and input/output (no isolation between input and output)
0°C to 55°C / -25°C to 70°C
EG8 (TS32 and TS35)
90mm x 12.7mm x 112.7mm max.
22-12AWG (0.5-4.0mm 2 )
7mm
0-4-0.8Nm
CSA (file LR-42272), UL (file E99775), CE marked (EMC dir. 89/336/EEC, LV dir. 73/23/EEC)
Cat.No.
G438 (factory calibration: 0-100% In, 4-20mA Out)
HS01-A (1.6mm) (conditionally required depending on installation, see heat sink data)
Note: G438-000X where X is the revision level
Specifications subject to change without notice. 99990013 - 8/98 Printed in Canada