Weidmuller WAVE Analog PRO DC - Manual (Page 3)

3. Configuration
3.1 Equipment
A screwdriver with a width of 2.5 mm is required to adjust the unit and to
connect the wires to the terminals.
3.2 Opening the unit
Disconnect the plugs. Disengage the top
part of the housing by carefully pressing the
latches on both sides (1). Pull out the top
part of the housing and the electronics
section until they lock (2).
3.3 Settings
Set the input and output ranges, offset and
bandwidth using DIP switches S1, S2 and S3 as
indicated in the following tables. When selecting
a variable amplification or offset setting, an
additional adjustment can be made using the
Span (amplification) or Zero (offset) potentio-
meters located under the top cover (3).
Caution! Only use a screwdriver which is
properly insulated against the
voltage applied to the input
when fine adjusting the
potentiometers on the front.
19
1
2
1
3
Span
Zero
S1 S2
S3