Weidmuller WAVE Control: VMA Vac Voltage-Monitoring Module - Manual (Page 4)

11
3. Configuration
3.1 Equipment
A screwdriver with a width of 2.5 mm is required to adjust the unit and to
connect the wires to the terminals.
3.2 Opening the unit
Disconnect the plugs. Disengage the top part
of the housing by carefully pressing the latches
on both sides (1). Pull out the top part of the
housing and the electronics section until they
lock (2).
3.3 Settings
The input voltage and the output signals
are selected in accordance with the following
tables.
1
1
2
SW1