Weidmuller WI-I/O 9-L-T: Wireless I/O Transmitter Quick Start Guide v1.7 - Manual (Page 2)

WI-I/O 9-L Transmitter Unit Quick Start Guide
WI-I/O 9-L Transmitter Unit Quick Start v1.7 page 2 of 8
This document is the WI-I/O 9-L-T Wireless I/O Transmitter Unit Quick Start Guide and
contains the following sections:
Section Read this section if you want to …
Basic steps for using your unit Learn the basic steps for installing and using your unit.
Factory default configuration Understand how the transmitter sends information to the receiver.
Unit components Understand the different parts of your unit.
Antenna installation Learn how to install an antenna with your unit.
Resetting factory defaults Reset your unit to the original factory default settings.
Linking transmitter and receiver units Link your units to work as a dedicated pair.
Safety information Understand important safety information related to your unit.
NOTE : You must read this information before installing your unit.
Specifications Know technical information about your unit.
For more information, see the next sections.
This document describes how to configure your unit using the default factory configuration that
lets you easily setup your network as a simple send/receive network using a dedicated pair of
transmitter and receiver units.
The basic steps for using your unit are:
1. Connect the antenna, power supply and transducer signals using the instructions in
this document. Power supply and transducer connection is described in the section
Unit components and connections . Antenna connection is described in the section
Antenna installation . For more information, see the WI-I/O 9-L-x Install Manual .
2. Reset the transmitter and receiver units to the factory default configurations.
3. Link the transmitter and receiver units to work as a dedicated pair.
4. Bench test your configuration before deploying.
NOTE : You can also configure your network using a user-defined customised configuration that
lets you set specific information about your network. For more information on setting a user-
defined customised configuration, see the WI-I/O 9-L-x User Manual on the enclosed CD.
When you configure the units using the configuration in this document, the inputs from the
transmitter are sent to the outputs at the receiver as follows:
WI-I/O 9-L-T (Transmitter) Sends WI-I/O 9-L-R (Receiver)
Digital Input 1 Digital Output 1
Digital Input 2 Digital Output 2
Analogue Setpoint Digital Output 3
Analogue input (4-20 mA) Analog output
Thermocouple Input (Not used)
Setpoint Output (Local indication)
Communication Failure (Comes on if no messages from WI-I/O 9-
L-T)
System OK (On if system OK) System OK (On if system OK)