Weidmuller WI-I/O-EX: Wireless I/O Expansion Modules v1.11 - Manual (Page 22)

WI-I/O-EX Serial I/O Module User Manual v1.11
Page 22 February 2010
Finally, you will be prompted to select the
module address. You can choose to allow
the configuration software to select an
unused address for you, or you can select
the module address manually.
- Serial Module address must be in the
range 96 to 127.
- Every serial module that is
connected to the same radio module
needs a separate address.
- You can use the same address on
two different serial modules if they
are connected to different radio
modules.
Once you have added the new module you can configure it in the same way as for 105
series modules.
For more information on configuring these modules using the WI Series software, refer to
the WI-I/O-9 user manual.
Figure 3-3: Select unit address.