Weidmuller WI-I/O-EX: Wireless I/O Expansion Modules v1.11 - Manual (Page 26)

WI-I/O-EX Serial I/O Module User Manual v1.11
Page 26 February 2010
4.3 WI-I/O-EX-11 configuration
4.3.1 Pulsed Inputs
Choose the Pulse Inputs Setup page, as shown in Figure 4-4.
Figure 4-4: Pulse inputs setup. Only available on a WI-I/O-EX-11 module.
Clicking the Read from WI-I/O-EX button reads the existing maximum pulse rate settings
from the WI-I/O-EX and displays them on the form.
If pulse rate is to be used, the maximum pulse input rate must be set. The pulse rate value
is calculated as a fraction of the maximum pulse input rate. Specify the maximum pulse
input rate in pulses per minute. The highest allowable pulse input rate is 60000 pulses per
minute, or 1kHz.
Once the maximum pulse rates are specified, click the Save Max Rates button to save the
data to the WI-I/O-EX module.
The pulse input feature can be tested on the DIO Check page (refer section 5.1).