Western Digital My Book World Edition (white light) User Manual - Manual (Page 17)

MY BOOK WORLD EDITION BASIC SETUP - 11
MY BOOK WORLD EDITION
USER MANUAL
My Book World Edition Basic Setup
Step 1: Connect My Book World Edition to the Network
Follow the steps below to connect the My Book World Edition to a small
home/office network.
1. Connect one end of the Ethernet cable into the Ethernet port located on the back
of the device.
2. Connect the other end of the Ethernet cable directly into a router or network
switch port.
Note: For faster initial loading of your content, connect the cable directly to the network port of your
computer. See page 176 for more information.
3. Connect the end of the adapter into the DC power supply socket located on the
back of the device.
4. Plug the AC adapter into a power outlet. The unit powers up automatically .
Important: Wait for the My Book World Edition to finish powering up
(approximately three minutes) before configuring the device. During this
time, do not press the power button. The bottom LED on the front of the My
Book device fully illuminates.
To power down the device, press and hold down the power button down for at
least four seconds.
2
1
2
3
4