Western Digital WD Sentinel DS6100 Administrator and Maintenance Guide - Manual (Page 83)

TROUBLESHOOTING
77 WD SENTINEL DS5100/DS6100
ADMINISTRATOR AND MAINTENANCE GUIDE
Imminent
Failure Boot
Drive <Drive
Name> S.M.A.R.T early detection found a
premature drive failure condition on
one of the boot drives. Replace the defective drive as soon
as possible to stop RAID from
going into a degraded state.
Invalid Drive The inserted drive is not compatible
with the device. Replace the inserted drive with an
approved drive. See
Dashboard>Monitor> Tasks for a
list of approved drives.
Invalid Drive
Capacity The new drive capacity is either
greater or smaller than the drive you
replaced. Replace the inserted drive with a
drive that has the correct drive
capacity.
Network
Disconnected The ethernet port does not have
network activity. Restore network connectivity.
Power Supply
<Supply #>
Failed Power supply 1 or 2 failed. Replace the defective power
supply.
• Access the Dashboard (See
“Accessing the Dashboard” on
page 25.)
• Click Monitor on the navigation
bar.
• Check the Power Adapter area to
review the status of your power
supply.
• Obtain and install a comparable
power supply.
Reboot
Required The system requires a reboot. Safely reboot the system.
Software
Update
Complete The software update process is
complete. Check the Alert Viewer to verify the
completion of the software update.
Software
Update
Downloading A software update is being
downloaded to the system. Allow the process to fully complete.
No action is required.
Software
Update Reboot
Required The software update is complete.
The system requires a reboot. The reboot is normally automatic. If
it does not occur, perform a manual
reboot.
WD Software
Update
Available There is a WD software update
available for download. Access and perform the update.
• Access the Dashboard (See
“Accessing the Dashboard” on
page 25.)
• Click Monitor on the navigation
bar.
• Click the Software Update tab.
• Click Check for Updates.
• Click Download and Install to
update the software.
WD Software
Update Failed The WD software update failed. Repeat the Software update
process again.
LCD Description Troubleshooting