WORX WU420 400W VERSACUT Saw - Manual (Page 11)

11
3) Clean the replacement saw blade and all the clamping parts to be
assembled. Slide the saw blade up through the slot and fit it onto
the inner spindle. Assemble the blade clamping washer (18) and the
spindle clamping screw (17). Use the two spanners to tighten the
spindle clamping screw thoroughly.(See Fig. C)
The steps involved in changing the blade are the same as the steps
used when installing the blade.
NOTE: Remove both spanners after the saw blade is tightly
attached.
WARNING: When mounting, ensure that the cutting direction of
theeth (direction of arrow on saw blade) and the direction-of-rotation
arrow above the blade guard match.
NOTE: Never use a blade that is too thick to allow the blade clamping
washer to engage with the flat side of the spindle.
The table below gives you advice on how to choose correct
blade.
Blade type Cutting material
TCT 24T Wood and aluminum
HSS 44T Thin sheet steel and aluminum, PVC pipe, plastic .
Diamond Concrete, marble, tile , cement backerboard.
Recommended maximum material thickness
Wood 27 mm
Aluminum 3 mm
PVC pipe (radius) 13 mm
Tile 8 mm
Sheet steel 0.91mm(20gauge)