WORX WU420 400W VERSACUT Saw User Manual
Page 14
14
work piece, based on the blade depth that was selected.
Always practice in a scrap work piece to become familiar with this
cutting operation. The selected depth of cut is now set. When the
saw’s blade is manually lowered, the blade will be below the base at
the selected depth.
The laser is used as a cutting guide and should form a red line on
the material surface that is exactly aligned with the blade alignment
indicator (12).
Press down the laser on/off switch (5) to turn on the laser.
Press down the laser on/off switch again to turn off the laser. (See
Fig. I)
NOTE: Clean the laser generator periodically.
WARNING: Never stare directly into the laser beam and never
point the beam at anybody. The laser beam energy is extremely
harmful to human eyes.
WARNING: When not in use, always turn the laser off to save
the battery capacity.
TO REPLACE LASER BATTERIES (See Fig. J1-J6)
The saw comes with laser batteries well assembled. When battery
capacity runs out, replace batteries as follows:
Use 1.5V batteries model LR44, typical to calculators, cameras and
similar small electronics.
Move the battery storage cover (16) in the direction the arrow (on the
cover) points. Then lift the battery storage cover (See Fig. J1, J2).
You can see one end of a cord. To remove the batteries, just slowly
pull the end of the cord. The two batteries will be taken out along
with the cord (See Fig. J3).
To fit new batteries, adjust the position of the cord and insert two
batteries in place. Make sure two batteries are pressed on the cord
(See Fig. J4, J5).
3
22
J1
J2
J3
J4
J5
J6
K
L
M
N
16
22
J1
J2
J3
J4
J5
J6
K
L
M
N
16
22
J1
J2
J3
J4
J5
J6
K
L
M
N
16
22
J1
J2
J3
J4
J5
J6
K
L
M
N
16
22
J1
J2
J3
J4
J5
J6
K
L
M
N
16