WORX WU420 400W VERSACUT Saw - Manual (Page 17)

17
Working hints for your circular
saw
If your Versacut becomes too hot, please run your Versacut TM no
load for 2-3 minutes to cool the motor. Avoid prolonged usage under
strenuous cutting loads.
Protect saw blades against impact and shock. Excessive feed
significantly reduces the performance capability of the machine and
reduces the service life of the saw blade. Sawing performance and
cutting quality depend essentially on the condition and the tooth
count of the saw blade. Therefore, use only sharp saw blades that are
suited for the material to be worked.
Choice of blades: 24 teeth for general work, approx. 40 teeth for finer
cuts, more than 40 teeth for very fine cuts into delicate surfaces,
diamond for tile, cement board, etc.
Maintenance
Remove the plug from the socket before carrying out any
adjustment, servicing or maintenance.
Keep tools sharp and clean for better and safer performance. Follow
instructions for lubricating and changing accessories. Inspect tool
cords periodically and if damaged, have repaired by authorized
service facility. Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in your power tool.
Never use water or chemical cleaners to clean your power tool. Wipe
clean with a dry cloth. Always store your power tool in a dry place.
Keep the motor ventilation slots clean. Keep all working controls free
of dust.
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
Periodically clear dust and chips from guard and base to ensure
proper performance.