Yamato Scientific BBL300 Low Constant Temperature Water Bath - Manual (Page 7)

4
Before Using This Unit
Requirements for Installation
WARNING!
1. Choose a proper place for installation
• Do not install this unit in a place where:
♦ Rough or dirty surface.
♦ Flammable gas or corrosive gas is generated.
♦ Ambient temperature above 30°C.
♦ Ambient temperature fluctuates violently.
♦ There is direct sunlight.
♦ There is excessive humidity and dust.
♦ There is a constant vibration.
♦ Winds from the air conditioner, etc. hit the sample container directly.
• Install this unit on a stable place with the space as shown below.
More than
20cm
More than
20cm
More than 20cm
More than 20cm
Main Unit
2. Installation on horizontal surface
• Place this unit as flat a place as possible. If the
four feet are not in uniform contact with the floor
surface, noise or vibration may result.
Additionally, the unit may cause a problem or
malfunction.
• Weight of unit is BBL100 type: 35kg BBL300
type: 55kg. Conveyance and installation should
be done carefully by two or more persons.
3. Before/after installing
• It may cause injure to a person if this unit falls down or moves by the earthquake and the
impact. etc..To prevent, take measures that the unit cannot fall down, and not install to busy
place.