Yukon Trail Dirt Hawk 20 Owners Manual - Manual (Page 12)

DO NOT RETURN STORE. For questions regarding assembly and use, call Customer Service: 877-441-6999.
Battery Gauge
When the throttle or sensor is engaged (Powering the motor) and the bicycle
is in motion, the LED’s on the battery gauge (on the throttle or separate unit)
indicate instantaneous line voltage as measured at the battery terminals- and
not the available energy in the battery pack.
The line voltage will fluctuate depending on the instantaneous load that the
motor is under. For example ,when starting out from a dead stop, or going up
a steep hill, the motor will be under a high load and may show a reduced
number of LED’s or show the “Yellow” or even “Red” LED.
When the throttle is disengaged (i.e. no power to the motor due to the
bicycle being stationary or coasting) the LED’s on the throttle will indicate
the voltage of the battery pack. The voltage of the battery pack will rise
when no load is on the motor. The best indication of how much battery life is
remaining is to check the throttle LED’s, after reaching cruising speed, on a
flat straight road as this will allow the battery voltage to stabilize and give a
much more accurate reading.
The LED’s 790 type with 3 speed you can also choose on the LED’s 790,
MODE (
LOW , MED , HIGH ).
TAG Throttle with Battery Gauge for SLA battery E-bike
TAG Throttle and Individual Battery Gauge for Li-ion battery E-bike