Yukon Trail Dirt Hawk 20 Owners Manual - Manual (Page 20)

DO NOT RETURN STORE. For questions regarding assembly and use, call Customer Service: 877-441-6999.
How to use the Li-ion battery charger
1. Red light means charging
2. Green light means charge-full
3. Input: AC100-240V
～, 1.6A (Max) 50/60Hz
4. Output: 42.00V—2.0A
5. Plug the charger into the outlet and turn the charger “ON” via the switch
on the black side. The red power light on the front of the charger will
illuminate when the charger is working properly.
6. Insert the XLR plug into the charger port on the bike being sure the charger
plug is fully seated in the charger port. The second light will start to flash
orange for several seconds while the charger is “seeking” the battery.
7. Once the charger has “found” the battery the blinking orange light will
stop flashing and turn solid orange and cooling fan will start. At this point the
charger process has begun.
8. Once the battery reaches full charger, the orange light will turn solid
green.
9. When charging is complete, unplug the charger from the wall before
removing it from the charger port.
Charge for the full time. If the battery still has not charged, you may need to
replace it.
Use only Yukon Trail Authorized Li-Ion chargers with bicycles
equipped with Li-Ion batteries.
Using any other charger will damage the batteries and void your warranty.
CAUTION
RISK OF ELECTRIC SHOCK, DRY LOCATION USE ONLY. SEE INSTRUCTION
MANUAL FOR USE.