Zero Gravity Kawasaki Z1000 (10-11) Windscreen - Manual

WWW.ZEROGRAVITY-RACING.COM
16-227 install
Rev B
Note: If the two upper fasteners are not grabbing the wellnut threads,
you will have to reach behind the two upper wellnuts and push
them against the fasteners to start the screwing process.
8. Tighten all 4 windscreen fastener screws so that the windscreen is
firmly in place. DO NOT OVER-TIGHTEN!
Installation Instructions for Double Bubble ® Windscreen 2010-2013 Kawasaki Z1000
Thank you for purchasing one of Zero Gravity’s windscreens which has been designed and manufactured to give years of safe
and fun riding. This instruction manual gives you an in-depth look at the
installation process. To receive further assistance or parts
please e-mail [email protected].
Spacer installed
between wellnut
and screen.
Well Nut
Locations
Fasteners
Washers
Spacers
Wellnuts
Windscreen
1. Remove the factory wind
screen.
2. Before installing your new Zero
Gravity screen, locate the 2 spacers pro-
vided with your windscreen.
3. Place your Zero Gravity windscreen on the bike and align the wind-
screen holes with the windscreen bracket holes.
4. Insert two of the four original windscreen fastener screws and wash-
ers into the two bottom holes and screw them into the threaded re-
ceptacles a few turns into the wellnut.
5. Lift the rear edge of the screen so the screen tilts up slightly.
6. Place the spacers between the windscreen and the windscreen
bracket so they align with the upper holes of the windscreen and the
Well Nut receptacle holes of the bracket.
7. Insert the two remaining fasteners and washers into the upper wind-
screen holes so that they pass through the windscreen and spacers
and then into the threaded receptacle.
Spacer is inserted
where the circle shown
SPORTBIKE SADDLES & WINDSCREENS
WWW.ZEROGRAVITY-RACING.COM
16-227 install
Rev B
Note: If the two upper fasteners are not grabbing the wellnut threads,
you will have to reach behind the two upper wellnuts and push
them against the fasteners to start the screwing process.
8. Tighten all 4 windscreen fastener screws so that the windscreen is
firmly in place. DO NOT OVER-TIGHTEN!
Installation Instructions for Double Bubble ® Windscreen 2010-2013 Kawasaki Z1000
Thank you for purchasing one of Zero Gravity’s windscreens which has been designed and manufactured to give years of safe
and fun riding. This instruction manual gives you an in-depth look at the
installation process. To receive further assistance or parts
please e-mail [email protected].
Spacer installed
between wellnut
and screen.
Well Nut
Locations
Fasteners
Washers
Spacers
Wellnuts
Windscreen
1. Remove the factory wind
screen.
2. Before installing your new Zero
Gravity screen, locate the 2 spacers pro-
vided with your windscreen.
3. Place your Zero Gravity windscreen on the bike and align the wind-
screen holes with the windscreen bracket holes.
4. Insert two of the four original windscreen fastener screws and wash-
ers into the two bottom holes and screw them into the threaded re-
ceptacles a few turns into the wellnut.
5. Lift the rear edge of the screen so the screen tilts up slightly.
6. Place the spacers between the windscreen and the windscreen
bracket so they align with the upper holes of the windscreen and the
Well Nut receptacle holes of the bracket.
7. Insert the two remaining fasteners and washers into the upper wind-
screen holes so that they pass through the windscreen and spacers
and then into the threaded receptacle.
Spacer is inserted
where the circle shown
SPORTBIKE SADDLES & WINDSCREENS