Zero Gravity Honda VFR 1200F (2010 and up) Windscreen - Manual

Honda VFR 1200F 2010 - 2013 DIY Windscreen Install
1
455 install
SPORTBIKE SADDLES & WINDSCREENS
Fig 2A. HERE IS THE TRICKY PART! Locate the
fairing retention clip and windscreen T-Hooks before
applying any movement pressure. There will be
two T-Hooks, one on each side.
(See FIG3).
Fig 2. After removing the mirrors, flex the corner fair-
ing to expose the next step in unhooking the stock wind-
screen as shown in
Fig 3.
Helpful hints: Use metric tools, clean hands, put the bike on a stand. Do not pry on the screen excessively, as it can break
without warning.
Installation Instructions for Honda VFR 1200F 2010 and up.
Thank you for purchasing Zero Gravity windscreen, which has been designed and manufactured to give years of safe &
fun riding. These instructions give you an in-depth look at the
installation process. To receive further assistance or parts please
e-mail [email protected].
PLEASE READ BEFORE MOUNTING YOUR WINDSCREEN
FIG2
FIG2A
Fig 3. Separate T-Hooks from the retention clip by
applying a light pressure from the corner fairing and
work the light pressure down as shown. (Both Sides)
Be careful not too exert to much force!
FIG3
Fig 1. Remove both mirrors. Locate both fasteners
located on the inside fairing. Also, remove inner plas-
tic that’s covering both left & right two allen screws.
Fairing
T-Hooks
Clip and T-Hook must
be separated before
removing screen .
Flex the
corner of
the fairing.
(Both sides)
Fairing
Retention
Clip
FIG1
Remove two
allen screws
(bothsides)
WWW.ZEROGRAVITY-RACING.COM