3D Robotics Tarot GoPro Video Cable - Manual (Page 2)

Connect OSD
Connect the end of the video cable with the more widely spaced wires to the
inner row of three pins on the OSD board with the wire farthest from the other
connector closest to the long side of the board (labelled VIN on the other side
of the board).
Connect to video system
Now you’ll need to connect the cable to your video system. If you would like to
see the data from the on-screen display (OSD) overlaid onto the GoPro video,
follow the instructions to connect to the OSD. To bypass the OSD and view
only the video as the GoPro captures it, follow the instructions to connect the
transmitter. The two-headed end of the GoPro cable has one connector with
widely spaced wires and one connector with closely set wires. You’ll be using
the connector with the more widely spaced wires.
Connect transmitter
The transmitter for your video kit should be wired as shown below.
Disconnect the red, black, and white three-wire cable from the transmitter. Orient the
GoPro video cable with the pins facing down as shown below, and insert the connector
with the more widely-set wires into the three-pin connector on the transmitter where you
removed the original three-wire cable. Make sure that the side of the GoPro video cable
connector with the visible metal pins faces down, towards the side of the transmitter with
the heat sink (rectangular, silver plate), and the smooth, black side faces up.
smooth, black side of
connector faces up