Rockwell Automation SK-G9-RELAY-F9 700 Phase Monitor Relay - Frame 9 User Manual
Powerflex 700 phase monitor relay replacement, Installation instructions, Sk-g9-relay-f9
Installation Instructions
20B-IN027A-EN-P
PowerFlex 700 Phase Monitor Relay Replacement
SK-G9-RELAY-F9
This publication provides the steps needed to replace a PowerFlex 700 Frame 9
Phase Monitor Relay. This relay verifies correct phasing of the three-phase blower
that is used for drive cooling.
Before proceeding, read the following:
For additional PowerFlex 700 drive information, refer to the following
publications online at:
www.rockwellautomation.com/literature.
To order paper copies of technical documentation, contact your local Rockwell
Automation distributor or sales representative. To find your local distributor or
sales representative, vi
For Drives Technical Support see
ATTENTION: This drive contains ESD (Electrostatic Discharge) sensitive
parts and assemblies. Static control precautions are required when
installing, testing, servicing or repairing this assembly. Component
damage may result if ESD control procedures are not followed. If you are
not familiar with static control procedures, reference Guarding Against
Electrostatic Damage, publication 8000-4.5.2 or any other applicable ESD
protection handbook.
ATTENTION: Only qualified personnel familiar with adjustable frequency
AC drives and associated machinery should perform maintenance/repair of
the system. Failure to comply may result in personal injury and/or
equipment damage.
ATTENTION: To avoid an electric shock hazard, verify that the voltage on
the bus capacitors has discharged before performing any work on the
drive. Measure the DC bus voltage at the +DC & –DC terminals of the
Power Terminal Block (refer to the User Manual for location). The voltage
must be zero.
Title
Publication
PowerFlex 700 Series B User Manual
20B-UM002
Frame 7-10 Installation Instructions
20B-IN014
Wiring and Grounding Guidelines for PWM AC Drives
DRIVES-IN001
Preventive Maintenance of Industrial Control and Drive System Equipment
DRIVES-TD001
Safety Guidelines for the Application, Installation and Maintenance of Solid
State Control
SGI-1.1
A Global Reference Guide for Reading Schematic Diagrams
100-2.10
Guarding Against Electrostatic Damage
8000-4.5.2