Rockwell Automation 20P PowerFlex DC Drive - Frame D Bimetal Thermostat User Manual
Rockwell Automation Equipment
PowerFlex® DC Drive
Frame D Bimetal Thermostat
Installation Instructions
What This Kit Includes
•
Bimetal thermostat and cable with connector
•
Thermal grease
Tools That You Need
•
Flathead screwdriver
•
Hexalobular screwdriver
•
Torque wrench
What You Need to Do
The bimetal thermostat is located on the heatsink of the U phase SCR leg
assembly in the drive. To install the bimetal thermostat:
❐ Step 1: Remove power from the drive
❐ Step 2: Remove the protective cover and open the control panel
❐ Step 3: Remove the existing bimetal thermostat
❐ Step 4: Install the new bimetal thermostat
❐ Step 5: Install the protective cover, close the control panel and document
the change
ATTENTION: Only qualified personnel familiar with DC drives
and associated machinery should plan or implement the installation,
start-up and subsequent maintenance of the system. Failure to comply
may result in personal injury and/or equipment damage.
ATTENTION: To avoid an electric shock hazard, ensure that all
power to the drive has been removed before performing the following.