Rockwell Automation 20P PowerFlex DC Drive - Frame D Bimetal Thermostat - Manual (Page 3)

3
Publication 20P-IN061A-EN-P
Step 2: Remove the
Protective Cover and Open
the Control Panel 1. Loosen, but do not remove, the six hexalobular screws that secure the
bottom protective cover to the drive, then slide the cover down and off the
drive chassis. Tightening torque for reassembly is noted in the illustration
below.
2. Disconnect the DPI cable from the HIM (if necessary).
3. Insert a flathead screwdriver into the holes in the right side of the protective
covers on the drive and turn the latch 90° counter-clockwise.
4. Open the control panel to the left.
Bottom
protective cover
Tightening torque:
1.5 N•m (13 lb•in)
T15
=
90°
Remove DPI cable