Rockwell Automation 23P PowerFlex DC Stand-Alone Regulator (SAR) Field SCR Module and Dual Diode Module - Manual (Page 7)

Rockwell Automation Publication 23P-IN004A-EN-P - June 2011 7
2. Remove the ribbon cable from its plastic hoop harness (if needed to make more room
for removing the mounting screws).
3. Remove the mounting screws (4, long) to the field power terminals, and save for
reassembly.
4. Remove the mounting screws (3, medium) from the dual diode module, and save for
reassembly.
5. Remove the mounting screws (3, medium) from the field SCR module, and save for
reassembly.
6. Remove the mounting screw (1, short) for the transducer cable to the glastic
stand-off. Save the transducer cable and mounting screw for reassembly.
7. Remove the stand-off and washer from the heatsink, and save for reassembly.
8. Lift the front edge of the field circuit board up at an angle and carefully pass the
mounting screw wells over the glastic spacer stack, and remove the field circuit board.
IMPORTANT
Lift the Front of
the Field Circuit
Board at an
Angle Until you
can Pull the
Mounting
Screw Wells
Over the Glastic
Spacer Stack.