Rockwell Automation 20P PowerFlex DC Drive - Frame A Switching Power Supply Circuit Board Fuse - Manual

Installation Instructions
PowerFlex
®
DC Drive - Frame A Switching
Power Supply Circuit Board Fuse Replacement
What This Kit Includes
•
One Replacement Fuse:
– Frame A drives with Switching Power Supply circuit board, SW1-31,
rev. H & below - One 5x20mm, 1A 250V Fuse
– Frame A drives with Switching Power Supply circuit board, SW1-31,
rev. I & above - One 5x20mm, 2.5A 250V Fuse
•
Fuse holder cap
What You Need to Do 1. Remove and lock-out all incoming power to the drive.
ATTENTION: To avoid an electric shock hazard, ensure that
all power to the drive has been removed before performing the
following.
L1 L2 L3
O
I