Rockwell Automation 20P PowerFlex DC Drive - Frame D In-Rush Limiting Resistor User Manual
Rockwell Automation Equipment
PowerFlex® DC Drive
Frame D In-Rush Limiting Resistor
Installation Instructions
What This Kit Includes
•
One in-rush limiting resistor (10R 75W, or 15R 75W for 690V AC input)
•
Static strap
Tools That You Need
•
Flathead screwdriver
•
Phillips® screwdriver
Phillips® is a registered trademark of Phillips Screw Company
What You Need to Do
The in-rush resistor is secured to the back wall of the drive frame below the
control pan.
ATTENTION: Only qualified personnel familiar with DC drives
and associated machinery should plan or implement the installation,
start-up and subsequent maintenance of the system. Failure to comply
may result in personal injury and/or equipment damage.
ATTENTION: To avoid an electric shock hazard, ensure that all
power to the drive has been removed before performing the following.
ATTENTION: This drive contains ESD (Electrostatic Discharge)
sensitive parts and assemblies. Static control precautions are required
when installing, testing, servicing or repairing this assembly.
Component damage may result if ESD control procedures are not
followed. If you are not familiar with static control procedures,
reference A-B publication 8000-4.5.2, “Guarding Against
Electrostatic Damage” or any other applicable ESD protection
handbook.
In-rush resistor