Rockwell Automation 56AMXN Command Central Quick Start Guide - Manual (Page 5)

Command Central 5
Configuring the AutoMax Programming Executive
1. Run the Programming Executive and select Setup/Communication…
2. Set the Communication Type to PC Link Interface Module.
3. Set the Drop Number to any valid drop number that isn’t being used by an AutoMax processor that you
are going to program. (The setting doesn’t matter but the software will not show its own drop number
in the list of available AutoMax processors).
4. Set the Segment and Port to match the settings in the QTS PC Link Control Panel applet.
5. Click OK to accept the configuration.
6. Go online with the AutoMax Programming Executive.
Troubleshooting
Problem Explanation/Solution
Cannot select Enable
RSLinx CIP Path in the
Control Panel applet. Command Central has not been
installed.
Message “RsLinx Driver
Not Found. RsLinx Path
Not Set?” This message appears the first time you
run the Control Panel Applet, because
the path has not been set in RSLinx.
Message “VDD: Can't
allocate VDD Resources” Not enough computer resources left (low
on memory etc)
Message “VDD: Can't
install VDD IOHooks” Can't install a port address hook. The
Control Panel applet has the card's port
address set to an address used by
another device. Try a different port
address.
Message “VDD:
VDDInstallMemoryHook
Failed” Can't install the shared memory address
hook. The Control Panel applet has the
card's shared memory address set to a
memory segment used by something
else. Try a different address.